Teac NT-503 - Settings; Navigating the Settings Menu

20
Settings
1 Press the MENU button to show the setting items.
2 Turn the INPUT SELECTOR knob to show the setting
to be changed.
o You can also use the up and down (k, j) buttons on the
remote control.
The menu items appear in the following order.
UPCONVERT
PCM D-FILTER
DSD D-FILTER
CLOCK SYNC
LINE OUT
LINE OUT LEVEL
DIMMER
AUTO POWER SAVE
NET STANDBY*
NETWORK SETUP**
*For details, see the Network Manual.
**Shown only when the input source is NET/USBf
3 Press the INPUT SELECTOR knob to confirm the
selection.
o You can also press the ENTER button on the remote control.
o The currently set value is shown on the display.
4 Turn the INPUT SELECTOR knob to change the set-
ting value.
o You can also use the up and down (k, j) buttons on the
remote control.
o Press the MENU button to return to setting item selection.
5 When you are done changing settings, press the
MENU button to show the input source status
again.
o If you do not do anything for about 10 seconds, the display
will return to showing the input source status.