Teac W-520R - Page 12

ve
Press the DUB START HIGH or NORMAL button
to start dubbing. The indicator corresponding to
the button pressed will light.
NORMAL: Dubbing is performed at normal
speed.
HIGH: Dubbing is performed at twice normal
speed.
—— dus stTaRT —
— —
NORMAL, HIGH
——
. The PEAK PROGRAM LEVEL METER indicates
the TAPE | signal levels; the recording levels of
TAPE II will be set automatically (at the same
levels as TAPE 1).
PEAK PROGRAM LEVEL METER
LerT ——— == SS Se Se Se
- 20 2 0 6 3 OO 3 6 +8
Ce ——————
. After dubbing is completed, both decks stop
automatically, according to the setting of the REV
MODE button.
10. To stop dubbing, press either of the STOP
buttons.
STOP
Notes:
The settings of the REC LEVEL control and
DOLBY NR switch are ignored during dubbing as
they have no effect.
The <<, <4,» and &® butions do not
function during NORMAL speed or HIGH speed
dubbing. Also, REC MUTE and PAUSE do not
function during HIGH speed dubbing.
The sound quality of the dubbed tape may be
slightly worse than that of the original tape. For
this reason, multigeneration dubbing is not
recommended.
If there is a TV set near the W-520R during high
speed dubbing, it is possible that the TV's
horizontal scanning frequency (15.75 kHz) may be
recorded on the tape. If this occurs or to prevent it
in advance, dub at normal speed, switch off the
television or keep the deck a reasonable distance
away from the TV.
S12
Synchro reverse dubbing
The SYNC REV ‘button allows both decks to be
reversed at exactly the same time during dubbing.
This function is convenient when using tapes with
different lengths, to dub a tape with exactly the same
contents as the original.
1. Set the tape running direction of both decks to
the & (forward) direction, and set the REV MODE
switch to the => position.
REV MODE
CONT PLAY
lf) <>
Ss
2. Press the SYNC REV button (the indicator above
the button will light).
SYNC REV
—
3. Press either of DUB START buttons (HIGH or
NORMAL).
—— du stanT ——,
NORMAL HIGH
—S Ce
4. The tapes in TAPE | and Il travel as illustrated in
the chart "Synchro Reverse Dubbing Operation"
on page 13.
Notes:
@ If the original tape is shorter than the dubbed tape,
blank sections will be left at both ends of the
dubbed tape. To prevent this, use tapes with the
same length as far as possible.
e During high-speed dubbing with the SYNC REV
button engaged, when either deck stops at the
end of tape, the other deck performs normal-
speed running (playback or recording) till the end
of tape, at which point both decks are reversed
and high-speed dubbing is restarted.