Teac W-520R - Page 13

Synchro Reverse Dubbing Operation
TAPE | tape shorter than TAPE II
4
TAPE | tape longer than TAPE II
TAPE |
Play @
Reverse Side B
= 1 Side A
® @ Play
TAPE I
No signal recording
Recording ® ®
Side B
Side A
Reverse
Recording
No signal recording
@ When TAPE | reaches the end of the forward
side, TAPE | stops and TAPE II enters the "no
signal recording" mode.
@ When TAPE II reaches the end, both TAPE |
and II are reversed simultaneously then TAPE
| resumes reverse play and TAPE II resumes
recording.
@ When TAPE | reaches the end of the reverse
side, TAPE | stops and TAPE II enters the "no
signal recording" mode.
@® When TAPE II reaches the end, the deck
stops.
TAPE |
i
ae
ide
® SA
@ Play
TAPE Il
Recording ®
Side B
Reverse Side A
9
@ O) Recording
@ When TAPE II reaches the end of forward
side, TAPE II enters the record-pause mode
for the reverse side, while TAPE | continues
playback.
@ When TAPE | reaches the end, TAPE | and II
start reverse play and recording simultane-
ously.
@ When TAPE II reaches the end of the reverse
side, both TAPE | and II stop simultaneously.
Manual editing with REC MUTE and PAUSE
During normal-speed dubbing, you can edit the
dubbed tape as required using the REC MUTE and
PAUSE buttons. For example, you can record only
the required tunes from TAPE | to TAPE II skipping
unwanted tunes.
—— bus stant —
— —
NORMAL HIGH
Ca!) co
(Cy
@ During normal-speed dubbing, when the PAUSE
button is pressed, TAPE Il enters the record-
pause mode while TAPE | continues playback.
While listening to the sound from TAPE |, when it
reaches a section you want to dub, press the
PAUSE button again to restart recording on TAPE
I.
© During normal-speed dubbing, when the REC
MUTE button is pressed, TAPE Il enters the
record muting operation as in normal recording. To
restart recording on TAPE Il, press the PAUSE
button.
CAUTION:
Recording pre-recorded tapes, records, or
other published or broadcast material may
infringe copyright laws. Check before
recording.
a ee