12
Playback II (either TAPE I or TAPE II)
A
To stop playback, press the STOP (H) key.
B
To stop playback temporarily, press the PAUSE key. To
resume playback, press the PAUSE key again, or press the
PLAY (h or y) key.
While playback is paused, pressing the PLAY key whose direction
is opposite to the indicator (h or y) on the display, will switch
the playback direction. This does not release the pause function.
Press PAUSE or the same play key (h or y) again to start
playback on the other side of the tape.
C
Fast forward/Rewind
Press the m or , key while in stop mode to fast wind the
tape.
To stop the fast winding tape, press the STOP (H) key.
D
Tape counter
Press the COUNTER RESET key to reset the tape counter to
. You can use this function for easy relocation of any
desired point on the tape.
E
Pitch control (TAPE I deck only)
This control varies the pitch of the music during playback (This
control does not work during recording or dubbing).
Turning the PITCH CONTROL knob clockwise increases the
playback speed and raises the pitch up to +10%.
Turning the PITCH CONTROL knob counterclockwise reduces
the playback speed and lowers the pitch by a maximum of –10%.
F
To listen through headphones
WARNING
There is no level control for the headphones output. Beware that
sudden loud sounds may occur depending on recorded material.
You should avoid prolonged exposure to high volume sound as
this can damage your hearing.
Plug your headphones into the PHONES jack, and put on the
headphones.
Plugging into the PHONES jack does not disable the line
outputs.
Playback
To Next Page
Loading...
Need help?
General
