Team Grill pgd - Grill Lighting Instructions; IMPORTANT! BEFORE LIGHTING THE GRILL

If the
1.
2.
grill contains electrical components:
To protect against electric shock, do not immerse cord or plugs in water or other liquid.
Unplug components from the outlet when not in use and before cleaning. Allow the grill to cool
before putting on or taking off parts.
3. Do not operate the grill with a damaged cord, plug, or after the grill malfunctions or has been
damaged in any manner. Contact your local grill service provider or Team Grill for repairs.
4. Do not let the cord hang over the edge of a table or touch hot surfaces.
5. Do not use the grill for purposes other than intended.
6. When connecting, always connect the plug to the grill first, then plug the appliance into the
outlet.
7. Use only a Ground Fault Interrupter (GFI) protected circuit with this grill.
8. Never remove the grounding plug or use with a two-prong adapter.
9. Use only extension cords with a three-prong grounding plug, rated for the power of the
equipment, and approved for outdoor use with a W-A marking.
IMPORTANT! BEFORE LIGHTING THE GRILL
Finally, inspect the gas supply hose before turning on the gas. If there is evidence of cuts, wear, or
abrasion, the hose must be replaced before use. ALWAYS INSPECT THE HOSE BEFORE EACH USE
OF THIS GRILL.
Grill Lighting Instructions
CAUTION i
1. Do not store a spare LP cylinder under or near a barbecue grill, or other
heat sources. Never fill an LP cylinder beyond 80% full: a fire causing death
or serious injury may occur.
2. The gas pressure regulator provided with this outdoor cooking gas
appliance must be used.
3. Accessible surfaces may become hot.
4. Turn off LP supply at cylinder when appliance is not in use.
Grill Lighting instructions:
1. Read all lighting instructions before lighting.
2. iMPORTANT: Open the lid before lighting.
3. To ignite, push and turn the ignition burner control knob to _/HI.
4. Push the ignition button in to light the burner.
5. To light the left and right burners, push and turn the desired burner control knob to HI.
6. If ignition does not occur within 5 seconds, turn all burner controls off, wait 5 minutes and repeat the
lighting procedure.
7. If any of the burners do not light, refer to the match lighting procedure that follows.
Team Grill Patio Series GAME-DAY User Guide Page 22