UK
24
FAULT CAUSE SOLUTIONS
Presence
of ice on
evaporator.
Flap left open for
longer than the
product loading or
preparation time.
Remove the product
and position it in a
suitable storage place.
Move the main switch
to OFF and wait the
necessary defrost time.
Perform the startup
and product loading
procedure described in
this manual.
If the problem persists ,contact a qualified technician
lmportant: if these solutions are not successful, please contact
TECFRIGO’s Technical Servicing Department.
(*) The operator must never intervene if intervention by
qualified personnel is specified.
9 DISASSEMBLY OF THE SHOW -
CASE AND DISPOSAL
Disassembly and disposal may only be carried out by
qualified personnel.
R290
The R290 gas is a refrigerant that is not harmful
to the environment but HIGHLY FLAMMABLE.
IT IS ABSOLUTELY FORBIDDEN to proceed
with the demolition of the showcase WITHOUT
complying with the Regulations in force.
9.1 DISMANTLING FOR DEMOLITION
lf the display case is going to be scrapped, this creates two
separate problems:
• The first one is administrative: the competent public offices
must be notified that the machine is being scrapped so that
the documentation they have on file about the machine
can be cancelled.
The display case comes with a set of legal documents, such
as the manual, the nameplate and the various authorizations
that must be examined once the decision is made to demolish
the machine.
• The second one involves physically disposing of the
display case: to do this, it is essential to contact specialized
disposal companies or the manufacturer.
Proceeding with demolition of the display case is absolutely
forbidden unless these indications have been observed.
9.2 DISMANTLING FOR TRANSFER
If the display case needs to be dismounted in order to move it
to another area, proceed as follows:
▶ Disassembly must be carried out by qualified personnel or
directly by the manufacturer, being sure to separate and
identify (mark) all the components.
▶ Perfect organization during disassembly guarantees
perfect and safe reassembly.
▶ All the material must be kept in a dry area that is protected
against weather.
▶ With appropriate signs, indicate what you are doing.
▶ Disconnect the machine from the mains supply.
▶ Before remounting the machine, check the material
thoroughly for any damage.
9.3 DISPOSAL
This symbol on the product or on its packaging
indicates that this product may NOT be treated
as household waste.
Instead it shall be handed over to the applicable
collection point for the recycling of electrical
and electronic equipment.
The materials used in the machine do not pose a hazard or risk
to the operators but may instead be polluting to the environ -
ment if they are not handled correctly.
Each waste items must be treated, disposed of or recycled ac
cording to the classification and procedures provided for by the
legislation in force in the country of installation.
Adequate separate waste collection, therefore, helps to pre -
vent potential deleterious effects on the environment and
health, encouraging reuse and/or recycling of the materials of
which the machine is constructed.
Illegal disposal of the product by the owner entails the ap
plication of administrative sanctions provided for by cur
rent legislation.
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment
and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more detailed
information about recycling of this product, please contact your
local city office, your household waste disposal service or the
shop where you purchased the product.
To Next Page
