18
User’s manual
Weather-based control
in the controller menu.
corresponding pre-set temperature value using LEFT and RIGHT arrows.
Heating curve – it is a curve according to which the pre-set controller temperature is
on the basis of four pre-set temperatures for respective values of external temperatures.
accuracy and easiness of setting the course of this curve.
NOTE
is not available (Main menu-valve settings).
Room regulator
Room regulator – this option is used to select the type of room regulator cooperating with
the valve. The following options are available:
- Standard regulator – a two-state regulator. This settings refers to the regulator connected
directly to the valve controlling module.
the set temperature of the valve will be introduced (function available only with TECH room
regulator).
Change of pre-set valve temp. – this setting determines by how many degrees the valve
temperature is to increase or decrease with a single unit change in room temperature (see:
Return protection
This function enables the user to set the CH boiler protection against too cool water returning
user presets the minimum acceptable return temperature.
To Next Page
Loading...
