20
User’s manual
VI. Protections and alarms
a message informing about the detected problem.
Automatic sensor control
The alarm remains active until the fault is removed (the sensor battery or the sensor itself
is replaced) and alarm is deleted in the external controller
How to delete the zone alarm in the external controller
Select the zone in which the alarm occurred (indicated by the exclamation mark instead of
the number). Press EXIT – two options appear on the screen:
-Reset
The external controller re-attempts to communicate with the sensor (it may take up to
activates again.
-Deactivate
This option deactivates the zone altogether. It may be activated again by selecting Activate
in Main menu/Sensors/1..8 zones.
This alarm may also be deactivated via the Internet website. If the alarm is caused by
Fuse
WARNING
Higher amperage fuse should not be used as it may damage the controller.
To Next Page
Loading...
