TECH EU-290 v1 - II. Description of the Device

To Next Page

To Previous Page

TECH

II. Description of the device

EU-290 room regulator is intended for controlling the heating device (e.g. gas, oil or electric furnace

or the CH boiler controller). Its main task is to maintain the pre-set temperature in the flat by

sending a signal to the heating device (contact opening) when the desired temperature is reached.

Advanced software enables the regulator to fulfil a wide range of functions:

 maintaining the pre-set room temperature

 manual mode

 day/night program

 weekly control

Controller equipment:

 touch buttons

 front panel made of 3mm glass

 built-in temperature sensor

 batteries

Controller versions:

 v1 – wired, without backlight.

 v2 – wireless, with temporary backlight. It may be optionally equipped with a wireless

external sensor. This controller version cooperates with an additional signal receiver,

installed near the heating device.

 v3 – wired, with temporary backlight.

 v4 – wireless, intended for cooperation with an external controller (e.g. ST-266, ST-268)

III. Installation

The controller should be installed by a qualified person.