TECH EU-290 v1 - VII.C) Controller Functions

TECH
14
Parameters icons:
Time settings
Weekly control settings
Day from…
Comfort temperature
Night from…
Economical temperature
Optimum start / heating-
cooling mode selection (in
service menu)
Hysteresis
Enter service menu / zone
selection (EU-290v4)
Temperature sensor calibration
Channel selection
VII.c) Controller functions
The user navigates in the menu structure using , , + , - and MENU. In order to edit particular
parameters, press and hold MENU. Next, press to view the controller functions. The edited
parameter is flashing whereas the remaining parameters are not displayed. Use + and - to change
the parameter settings. Press to confirm the changes and move on to edit the next parameter
or press and hold MENU to confirm the changes and return to the main screen view (except for
editing weekly control and channel selection).
VII.c.1) Block diagram - main menu
Main menu
Day of the week
Time settings
Day from
Night from
Optimum start
Service menu
Heating/cooling mode
Channel selection ( EU-290 v2, EU-290 v4)
Zone selection( EU-290v4)Weekly control
Pre-set comfort temperature
Pre-set economical temperature
Hysteresis
Temperature sensor calibration