Techbase MBus Gateway - Configuration Using SSH; Scan Mbus Network

TECHBASE (C) MBus Gateway RTU 4/8
© 2014 TECHBASE
Group
Technical contact - support.techbase.eu 4/8
1. Choose
Devices
label from
side
menu.
2. Next
choose
your
device
from
device
list.
3. Now
you can
check
parametrs
list.
2.2 Configuration using SSH
2.2.1 Scan mbus network
MBus gateway can scan mbus network to find all the meters that are connected to the device. To
scan mbus network please use following command:
MBus-to-ModbusRTU using COM2 for MBus and COM4 for ModbusRTU
imod scan mbus -p /dev/ttySC0 -rtu-access COM4
MBus gateway create configuration file named “MBusScan.xml”. This configuration is contained all
the available parameters detected during a scan.