12
Display Explanation
Display: Symbols:
Appears when manual
cuff inflation is needed
Appears when cuff
deflation is needed
Appears when
batteries should be
replaced
Shows the pulse rate
per minute
Occurs when a
mistake was made
during measurement
Error Messages
Measurement Error: Make sure the T-plug is securely connected to the air socket
and measure again quietly. Wrap the cuff correctly and keep arm steady during
measurement. If error keeps occurring, contact the service center.
Air Circuit Abnormality: Make sure the T-plug is securely connected to the air
socket and measure again quietly. If error keeps occurring, contact the service
center.
Pressure Exceeding 300 mmHg: Press the air release valve to rapidly exhaust
the air in the cuff, switch the unit off, and measure again quietly. If error keeps
occurring, contact the service center.
Data error: Remove and reload the batteries. If error keeps occurring, contact the
service center.
Installing the Batteries
1. Press down and lift the battery cover in the
direction of the arrow to open the battery
compartment.
2. Install or replace 2”AA” sized batteries in the
battery compartment according to the
indications inside the compartment.
3. Replace the battery cover by clicking in the
bottom hooks first, then push in the top end of
the battery door.
Indicator
Diastolic Pressure
Pulse Rate
Weak Battery Indicator
Memory Sequence Number
Systolic Pressure
To Next Page
Loading...
