15
Memory
1. To recall stored blood pressure
readings from memory, simply press
the Memory button. The last set of
memorized readings will be displayed.
2. Another press of the Memory button
will recall the previous set of readings.
3. All readings stored in memory will be
displayed with its sequence number.
Clearing Values from Memory
Press and hold the “M” key for approximately 5 seconds, then the data in the memory zone can be
erased automatically.
Press and hold for 5 seconds.
Note: The data in the memory zone can be erased if any of the batteries is removed. Suggest the
users to first take record the data before replacing or moving away the batteries.
Helpful Tips
Here are a few helpful tips to help you obtain more accurate readings:
• Do not measure your blood pressure immediately after consuming a large meal. To obtain more
accurate readings, please wait one hour before measuring.
• Do not smoke or drink alcohol before measuring your blood pressure.
• It is important that you relax during measurement. Try to take a 20-minute rest before a reading.
• Do not take measurements if you are under stress or under tension.
• Take your blood pressure at normal body temperature. If you are feeling cold or hot, wait a while
before taking a measurement.
• If the monitor is stored at very low temperature (near freezing), have it placed at a warm location
for at least one hour before using it.
• Wait about 20 minutes before taking the next pressure measurement.
Troubleshooting
If any abnormality should arise during use, please check the following points.
Symptoms Check Points Correction
Have the batteries run down? Replace them with two new batteries.
No display
when the
POWER button
is pressed
Have the batteries’ polarities been
positioned incorrectly?
Re-insert the batteries in the correct
position.
Is the cuff placed correctly?
Wrap the cuff properly so that it is
positioned correctly.
Is the cuff pressure pumped
enough? (30~40 mmHg above normal
systolic value?)
Measure it again and pump up
30~40 mmHg more than normal
systolic value.
Did you talk or move during
measurement?
EE mark shown
on display or
the blood
pressure value
is displayed
excessively low
(high)
Did you shake the arm with the cuff on?
Measure it again quietly. Keep arm
steady during measurement.
To Next Page
Loading...
