Techly IDATA HDMI-MXB88 - Page 20

EN - 20
WWW.TECHLY.COM WWW.TECHLY.COM
8X8 HDMI MATRIX
4K@60HZ YUV 4:4:4 18GBPS
RS-232 Command Function description Feedback
s port 8000! Set control port at 8000 8000
snetworkenable!
Whenconfiguringnetworkmodules,execute
all the commands you need to configure first
and then execute this command to reboot
networkmodules
r ip addr! GettheIPaddressofthenetworkboard a a.b.c.d <CR>
r mac addr! GettheMACaddressofthenetworkboard a a-b-c-d-e-f <CR>
r subnet! Getthesubnetmaskofthenetworkboard a a.b.c.d <CR>
rgateway! Getthegatewayofthenetworkboard a a.b.c.d <CR>
r port! Getnetworkportnumber a 8000 <CR>
s net name ****! Setthenameofthenetworkmodule *******
r net name! Getthenameofthenetworkmodule a ******* <CR>
Note: In this table, you can send “RS-232 Commands” to control the product in
anyserialcommandtool.The“Functiondescription”willexplainfunctionabout
thecommand.The“Feedback”willdisplaywhetherthecommandsendssuccess
and feedback the information you need to.