Technaxx TE22 User Manual

Battery
voltage below
10 Voltage
Recharge or replace battery
Equipment
being
operated
draws too
much power
Allow Inverter to cool down. Ensure
there’s adequate ventilation around
the Inverter. Ensure that load is no
more than it’s maximum rating for
continuous operation
Low Voltage
alarm turns on
immediately
The input
voltage at
input of the
Inverter needs
to be raised
Recharge/Replace battery or add
additional batteries. Run the vehicle
engine when using a 12V DC plug
Low voltage
alarm is on all
the time
Power battery
condition with
voltage drops
Replace battery
Inadequate
power or
voltage drops
Check condition of battery cables
and cable leads. Clean or replace as
necessary
Low power
output
Battery
condition may
be poor
Recharge or replace a battery
Fault
connection
Make sure the battery and Inverter
terminal are clean
Inverter does
not work after
connecting the
cables in
reverse
The internal
protection has
disabled the
inverter
Contact vendor company for help
Warnings & Caution
⚫ Use of the device in life support applications where failure of the device can
reasonably be expected to cause the failure of the life support equipment or to
significantly affect its safety or effectiveness is not recommended. ⚫ Do not use the

Technaxx TE22 Specifications

General

Brand	Technaxx
Model	TE22
Category	Inverter
Language	English