4
Before first use
Charging
The TX-156 has an internal, rechargeable battery which must be
fully charged before use for the first time. It takes about 20 hours to
charge the battery fully by a common USB power adapter.
Please charge the TX-156 by using a common USB power adapter*
(DC 5V/1A) (*not included). While charging the charging indicator
LED (12) right to the MicroUSB port will turn RED. When the
TX-156 is fully charged, the charging indicator LED (12) will turn off.
MicroSD
Before using the device for the first time or after replacing the
MicroSD card, it must be formatted, so as to facilitate the
optimization of the TX-156. The MicroSD card can only be used
after the system has been formatted on a PC, which can otherwise
lead to errors.
Info: ⚫ Cards up to 32GB must be formatted in FAT32.
⚫ Cards of 64GB or more must be formatted in exFAT.
Operation
1. Make sure that nothing is blocking the lens (2) and motion sensor
(4) in front of the Solar outdoor camera.
2. Switch the Off mode to Photo or Video mode the red light turns
on, the first 30s will enter Status mode.
3. Move your hand in front of the motion sensor of the machine (just
for testing). The green light (14) will turn on and the red light (14)
will turn off once to indicate that the image is recorded/saved.
Info: After 30 seconds, the red light turns off and the TX-156 goes
into hunting mode. The camera will take photos or videos according
to the parameters set by the software on your computer (automatic
loop is turned on by default).
To Next Page
Loading...
Need help?
General
