5
Model: TX-203,TX-204 Article No. 5012,5013, 10/2022
⚫ Handle the product with care. It can be damaged by shocks, impacts or falling from
even a low height.
⚫ Keep the product away from extreme heat.
⚫ Never immerse the product in water or other liquids.
⚫ Technical changes and errors excepted!
Warning!
⚫ Do not install the device if the AC cable of the micro inverter is
damaged or broken.
⚫ Before installing or using the micro inverter, read carefully all the
instructions and safety notes in the user manual and on the device and
other solar equipment.
⚫ Do not connect the micro inverter to the operator grid until you have fully
implemented the installation process and received confirmation / approval from the
grid operator.
⚫ Do not tamper with or manipulate the micro inverter or other parts of the equipment
under any circumstances.
⚫ Risk of damage due to improper modifications!
⚫ Keep all contacts dry and clean!
Caution Risk of electric shock!
⚫ When operating this device, certain parts of the device are under
dangerous voltage, which can lead to serious physical injuries or death.
Therefore, follow the following instructions to minimize the risk of injury.
⚫ Disconnect the plug connection only in a de-energized state!
⚫ Before carrying out visual inspections and maintenance work, check that the power
supply is switched off and secured against being switched on again.
Caution, hot surface!
⚫ The surface of the micro inverter can become very hot. Touching the
surface can cause burns.
⚫ Mount the micro inverter in such a way that accidental contact is not
possible.
⚫ Do not touch hot surfaces. When working on the micro inverter, wait until the surface
has cooled down sufficiently.
Intended use
The micro inverter may only be operated with a fixed connection, Schuko plug (or plug
type of the corresponding country) or Wieland plug to the public power grid. The micro
inverter is not intended for mobile use. Modifications to the micro inverter are generally
prohibited. For changes in the environment, you must always consult a qualified
electrician. Assembly, installation and electrical connection.
To Next Page
Loading...
Need help?
General
