Indoor Monitor View the Camera
In standby mode, press “ ” monitor key on indoor monitor to monitor call. In
this mode, the blue LED lights up. If outdoor unit receives signal in 5 seconds,
then it connects to indoor monitor, indoor machine turns into normal monitor
mode and shows image and speaks voice of outside. There is no voice speaking
for outdoor unit. If outdoor unit doesn’t receive signal in 5 seconds, then it shows
“User not online” and exits monitor calling mode automatically and turns into
standby mode.
Two sets of outdoor units (Code connected successfully):
Press “ ” monitor key on indoor monitor to turn into monitor selection menu
-》 press “↑/↓” key to choose code of outdoor units -》 press “OK” to turn into
monitoring call mode, blue LED lights up (During selection, press “Exit” to turn
into standby mode ).
■ Intercom: in monitor mode, red LED lights up, there is voice speaking for
indoor monitor but not for outdoor unit -》 press “ ” to turn into both-way
communication, blue LED shuts down -》 press “ ” monitor key again to
turn back to one way voice monitor mode. (One or both-way voice could be
changed over repeatedly). Intercom time is 90seconds and shall be timed
again after changing over.
■ Unlock: in “OK” on-state mode -》 press “ ” unlock key -》 after
successful unlocking, it shows unlock icon.
■ Take a Photo: in monitor mode -》 press “ ” photo taking key -》 one
press one photo, the photos will be stored in MicroSD card.
■ Video Recording: in monitor mode -》 press “ ”video taking key -》
start taking video -》press “ ” video taking key again to stop, the videos
will be stored in MicroSD card.
■ End: in monitor mode -》press “OK” key -》 end monitor and turn back to
standby mode.
Note: in monitor mode, red LED lights up, in intercom mode, red LED shuts
down.
Indoor Monitor CALL Indoor Monitor (Intercom)
(Only can realize when there are 2 and more indoor monitors.)
In standby mode, if there are only two indoor monitors in system, press “OK” to
call another indoor monitor.
In standby mode, if there are three indoor monitors in system, press “↑” to call
small code indoor monitor; press “↓” to call large code indoor monitor;
■ If the CALLED indoor monitor doesn’t receive the signal in 4 seconds, the
CALL monitor shows “User not online”, it turns back to standby mode with a
sound of “Beep”.
■ If the CALLED indoor monitor receives the signal, two monitors play music,
red LED lights up.
■ If the CALLED indoor monitor doesn’t reply, the monitors turn into standby
mode after 30seconds.
■ If the CALLED indoor monitor replies by pressing “Ok”, music stops, red
LED shuts down, blue LED lights up to both of the monitors, and both
monitors turn into intercom mode, communication time is max. 90seconds.
■ The CALL indoor monitor has initiative hang up function.
■ During communication, if any end in the communication presses “OK”, then
both two ends hang up with a sound of “Beep” and turn to standby mode.
To Next Page
Loading...
Need help?
General