77
Put the power cord into the electrical socket (with 10A). Flip this switch to the “ON”
position. The screen will then power up.
ut the safety key on the correct position ,then turn on the power ,the LCD window light
is shining ,and sound “beep”, the treadmill is now in the ”P0 Normal Mode” .
“PROG” key to cycle select the program P0-P26.
a) “P0” User program. Press “MODE” cycle select four training mode. User can select the
speed and incline. Speed default is 1.0km/h. Incline default is 0%.
Training mode 1: Counting. Time, speed, distance calorie is plus. The select function
closes.
Training mode 2: Time Countdown. Once selected, the time window activates. Press “+”
or ”-“ to select. The range is 5-99 minute. Default is 30:00.
Training mode 3: Speed Countdown. Once selected, the speed window activates. Press
“+””-“ to select. The range is 1.0-99.0km. Default is1.0KM.
Training mode 4: Calories Countdown. Once selected, the calories window activates.
Press “+””-“ to select. The range is 20-990CAL. Default is 50CAL.
b) “P1—P12” Preset program. Only for “Time Countdown”. Once selected, the time window
activates. Press “+””-“ to select. The range is 5-99 minutes. Default is 30:00. Press “MODE” to
return to the Default value
: Press “start” key, the speed window will count down “3→2→1” then beep 3 times, and
then the treadmill belt will start moving.
a) When running, press the +, – and quick speed key to adjust the speed you want.
b) For P1—P26, Speed and incline divide into 10 segments. Each segment has the same
time. The speed and incline, once selected, will be available in current segment. When it runs
to the next segment, it will beep 3 times in advance. When it finishes 10 segments, the motor
will stop with a long beep sound.
c) Press “START” key when running, it will pause. Press “START” key again, it will restart,
the recorded data will continue.
Press “STOP” key when running, the treadmill will slow to a stop. It will return to the
default state.
“ “ KEY or “QUICK INCLINE KEY” adjusts the incline you want.
In any state, if you pull-out safety locks, window displays E7 and sounds the buzzer. The
treadmill stops.
: the main control board constantly fault checks the system and will bring the treadmill to
Start instruction:
(
Ⅵ
)
6.1:
6.2: P
6.3: Press
6.4
6.5:
6.6: Press
6.7:
6.8
To Next Page
Loading...
