Page 11 / 85
The lights on the front panel LEDs are described in the table below (from left to right):
ON = the LED is light, OFF = the LED is gray, FLASH = the LED is blinking.
From power ON to system initialization
complete
Following system initialization
complete to (before) DS scanning
DOCSIS
Start-up
Operation
During DS scanning and acquiring SYNC
From SYNC completed, receiving UCD
to ranging completed
During DHCP, configuration file
download, registration, and Baseline
Privacy initialization:
DHCP status: 1 second ON and 1
second OFF,
TFTP status: 0.25 second ON and 0.25
second OFF
Channel
Bonding
Operation
Wait registration with all DS and all
US – Lights Flash sequentially from the
right to left Minimum duration 3
seconds
From 1 to 4 DS, from 1 to 4 LEDs are
ON
From 5 to 8 DS, From 1 to 4 LEDs are
flashing
Duration 3 seconds
From 1 to 4 US, from 1 to 4 LEDs are
ON.
Wait registration with all DS and all
US – Lights Flash sequentially from the
left to right
RSIP for NCS/Register for SIP
No Ethernet / Wireless Link
Ethernet / Wireless Link
TX/RX Ethernet / Wireless Traffic
Tel1 Off-hook, Tel2 On-hook
Tel1 On-hook, Tel2 Off-hook