Technics RS-B765 - Page 5

RS-B755
Mi FRONT PANEL CONTROLS AND FUNCTIONS
el Ae) fy
[1] 2 3 4 [5] 6 7
ec QE ay
Tee’ Gor mee | Geeares wrx | OO
——<$<—Sa are
12 11
Power “standby © /on” switch
(power “standby () /on’’)
This switch switches ON and OFF the secondary circuit power
only. The unit is in the “standby” condition when this switch is
set to the “standby(!y” position. Regardless of the switch
setting, the primary circuit is always “live” as long as the
power cord is connected to an electrical outlet.
Open/close button (4 open/close)
This button can be used to open or close the cassette holder.
Cassette holder
Display section
Monitor switch (monitor)
In order to monitor the tape (check the recording condition),
the sound on the tape (immediately after recording) and the
sound of the sound source (the original sound, before
recording) can be alternately selected by pressing this button.
(The corresponding indicator will illuminate.)
-30-7 =-6 -15-5 -12-4 -10-3 -8- -6 -1
left
-4 2+
[6]
[9]
[i]
[12]
0+2
CUOUOOGOCUOOOOOENAGOUOUEOOROGUUSUOUOUOESUGUSUOURESECHUGUENONE
range
Recording-level control (rec level)
This control can be used to regulate the recording level and
the peak level.
Recording-balance control (balance)
This control can be used to balance the left and right sound
levels during recording.
Recording-calibration adjustment controls
(rec calibration)
The sensitivity differences (high or low recording levels) for
each tape type can be corrected by using these controls.
Bias-adjustment control (bias adjust)
The frequency response for each tape type can be equalized
by using this control.
Operation section
Headphones jack (phones)
Headphones volume control (phones level)
+2DO00+4+4 +6+5 +2 +7 +16+8 dB
+8 +6
right QRRGRRERUREDDOOUUUROCRRDRORUSRERROREROUROSERODOOERE
[Source] '
| (fape|APRS MPX
i memory
| repeat !77 crd2 IV/Metal {
stop)! a" 1/Normal H |i
an re
'
iT
1
Memory-mode indicators
(memory repeat/stop)
Each indicator illuminates to show which of the memory mode
was set by the memory-mode buttons.
[A] Input level meter
During playback, this meter indicates the level of the recorded
sound.
During recording, it indicates the level being recorded,
adjusted by the recording-level control.
Tape/Linear counter
Indicates the amount of tape movement or elapsed time.
[D] Tape-select indicators
The type of tape being used will be automatically detected
and the indicator will illuminate.
— 3 —