Technics RS-B765 - Page 6

RS-B755
[E] Monitor indicators ([source|/[tape])
[F]
Each indicator illuminates to show which of the monitor was
set by the monitor switch.
APRS indicator (APRS)
Illuminates to indicate that the “APRS” is set to “on” in the
recording stand-by mode.
[G)
[H)
Multiplex filter indicator (MPX)
llluminates to indicate that the multiplex filter is set to “on”.
Dolby noise-reduction indicators ([B), [C))
Each indicator illuminates to show the type of Dolby noise-
reduction system selected by pressing one of the Dolby
noise-reduction buttons.
[1]
[2]
counter —
mode
t repeat
Timer switch (4 timer)
This switch is used to automatically begin a tape recording or
tape playback at a certain time, selected by a timer (not
included).
Counter buttons (counter reset/mode)
reset: This button can be used to reset the tape/linear
counter indication to “OOO—”/00.00”.
mode: This button can be used to select the tape/linear
counter indication.
Memory-mode buttons (memory repeat/stop)
repeat: This button can be used to set this unit to the “A-B
repeat” mode.
(Refer to page 7.)
stop: This button can be used to rewind the tape to the
preset “0000” point when the rewind (<4) button
is pressed. (Refer to pages 7.)
Meter-range selector (meter range)
This selector can be used to select the meter-range display of
the input level meter.
Multiplex filter switch (MPX filter)
This switch can be used during the recording of an FM
stereo broadcast that employs Dolby noise reduction so as to
prevent misoperation of the Dolby noise reduction.
(Refer to page 5.)
Dolby noise-reduction buttons
(noise reduction)
These buttons are used to reduce the hissing noise heard
from the tape. This unit is provided with both the B-type and
C-type noise-reduction systems.
APRS button (APRS)
This button can be used to hold the peak level while
monitoring the input sound. (Refer to page 6.)
ee ee
1 |——memory —— |
stop
MPx filter] -— noise reduction — |
1 B—DolbyNR—C |
Record button and indicator (rec/@)
This button can be used to change the tape deck to the
recording stand-by mode.
This indicator illuminates to indicate that this tape deck is in
the recording stand-by mode, or is recording.
Automatic-record-muting button
(auto rec mute/Q)
This button can be used to make a silent interval on the tape
being recorded on tape deck.
Pause button (pause/If)
This button can be used to temporarily stop the tape playback
or recording of tape deck.
Rewind/fast-forward/search buttons
(rew/<<4, ff/>>)
These buttons can be used to fast forward or rewind the tape,
or to easily search for the tune’s beginning of the tape quickly.
Playback button and indicator (play/P>)
This button can be used to start the playback or recording of
the cassette.
(The tape will then begin moving in the left-to-right direction.)
When this indicator illuminates steadily, it indicates that this
tape deck is in the playback mode or the recording mode.
When it flashes continually, this is an indication that this tape
deck is in the pause mode or the recording stand-by mode.
Stop button (stop/H)
This button can be used to stop tape movement.