Technics RS-B765 - Page 9

RS-B755
i DISASSEMBLY INSTRUCTIONS
“ATTENTION SERVICER”
Some chassis components may have sharp edges. Be careful when disassembling and servicing.
Removal of the main P.C.B.
Procedure
1-2
1. Remove the 7 screws (@~@).
2. Remove the rear panel from the
projection of the bottom chassis.
Cabinet
Rear Panel
Bottom Chassis
Projection
eRemove the 6 screws (@~@).
3. Remove the 7 screws (O~ @®).
4. Remove the 2 connectors (CP1, CP2).
5. Remove the 5 flat cables (CN3, CN4, CN6,
CN10A, CN201).
6. Remove the main P.C.B. in the direction of the
arrow.
How to remove the flat cable
Pull out the flat cable ,
while pressing the
connector.
Connector
How to check the main P.C.B. 4. Remove the bottom board in the direction of the
When
checking
the
soldered
surfaces
of
main
P.C.B.
arrow
©.
and
replacing
the
parts,
do
as
show.
5.
Reinstall
the
front
panel
to
the
main
P.C.B.
1. Remove the 10 screws (9, ©, @~@®) in above
figure.
. Remove the 6 screws (@~ @).
. Remove the front panel in the direction of the
arrow ®.
@ Nh