Technics RS-BR465

Recording
3
4
| Technics
Stereo Cassotte Deck RS-BR465
“
power
Astandbyoaon
aeject
©OLJ]o
|
peak level meter(dB)
<] avutorevense [> |
© Quick Reverse/CD Synchro Edit
10
Normal recording
1
Set
the
power
switch
of
the
amplifier
to
ON,
and
select
the
input
source.
2
Set
the
timer
switch
to
OFF.
3
Set
the
power
switch
to
ON.
4
Press
the
eject
button,
and
then
insert
the
cassette
to
be
used
for
recording.
(The
part
of
the
cassette
where
the
tape
is
exposed
should
face
downward.)
5
Press
the
button
corresponding
to
the
Dolby
noise-reduction
system
(B
or
C)
to
be
used.
[The
Dolby
noise-reduction
(“B”
or
“C")
indicator
will
illuminate.]
If
no
Dolby
noise-reduction
system
is
to
be
used,
press
the
Dolby
noise-reduction
button
corresponding
to
the
Dolby
noise-reduction
indicator
that
is
illuminated.
(The
indicator
will
then
switch
OFF.)
6
Select
the
appropriate
reverse
mode.
[A
reverse-mode
indicator
(“=—*”
or
“c%>")
will
illuminate.]
=
Select
this
mode
to
record
on
one
side
only.
The
recording
will
stop
at
the
end
of
one
side
of
the
tape
depending
which
side
was
selected.
>
Select
this
mode
to
record
on
both
sides.
The
recording
will
be
made
on
side
“B”
after
recording
on
side
“A”;
the
tape
will
stop
at
the
end
of
side
“B”.
7
The
sound
source
to
be
recorded
should
be
played
before
the
recording
is
started
in
order
to
adjust
the
recording
level.
8
Press
the
record
button.
(The
recording
indicator
will
illuminate
and
the
playback
indicator
will
flash
continuously;
the
unit
will
be
in
the
recording
stand-by
mode.)
9 Adjust the recording level.
While
watching
the
level
on
the
meters,
adjust
the
“rec
level”
control
so
that
the
peak
indication
is
as
high
as
possible,
without
exceeding
the
indication
noted
in
the
chart
below.
Normal tape
Dolby NR B-C
10
Adjust
the
left/right
recording
balance.
11 Start the playback source from the begin-
ning.
12 Press the playback button.
elf only one side of the tape (reverse mode position:
== ) is to be recorded, press the playback button that
corresponds to that side.
eTo record on both sides of the tape (reverse mode
position: @.>), press the “A” side playback button
(Pm).
(The playback indicator will illuminate steadily, and the
recording will begin.)
@ To temporarily stop recording
Press the pause button.
(The playback indicator will begin flashing.)
To resume recording, press the playback button.
@ To stop recording
Press the stop button.
Note:
If this unit is used in combination with a Technics compact disc
player that has a synchro-edit terminal, switch OFF the compact
disc
edit
indicator
on
the
compact
disc
player
(by
pressing
the
stop
button on the compact disc player).
enveniceanangcvmitn spun nina atiingerci hese DL a th aN RARE MENSA CEA