Technics RS-BX828

COUNTER-—-
RESET MODE
RS-BX82
Control section II
®
@ © ®
©
Timer switch ( TIMER)
This switch is used to automatically begin a tape recording or
tape playback at a certain time, selected by a timer (not
included).
Counter buttons (COUNTER RESET, MODE)
RESET: This button can be used to reset the tape/linear
counter indication to “O00_/00.00”.
MODE: This button can be used to select the tape/linear
counter indication.
Memory-mode button
(MEMORY REPEAT/STOP)
REPEAT: This button can be used to set this unit to the
“A-B repeat” mode.
This button can be used to rewind the tape to the
preset “000_/00.00” point when the rewind (<<)
button is pressed.
Meter-range selector (METER RANGE)
This selector can be used to select the meter-range display of
the input level meter.
STOP;
Calibration selector (REC CAL.)
This selector can switch the input level display between the
level adjustment indicator and bias adjustment indicator.
APRS button (APRS)
This button can be used to hold the peak level while
monitoring the input sound.
Multiplex filter switch (MPX FILTER)
This prevents the Dolby NR circuit from operating in error
when FM stereo broadcasts are recorded using the noise
reduction function.
oi}
@) Dolby noise-reduction buttons
(B-DOLBY NR-C)
These buttons can be used to reduce the hiss noise that is
characteristic of tape. This unit is provided with both the Dolby
B type and C type noise-reduction systems.
Record button and indicator (@ REC)
This button can be used to change the tape deck to the
recording stand-by mode.
Automatic-record-muting button
(© AUTO REC MUTE)
This button can be used to make a silent interval on the tape
being recorded on tape deck.
Pause button (If PAUSE)
This button can be used to temporarily stop the tape playback
or recording of tape deck.
Rewind/fast-forward/search buttons
(<< REW, PP FF,
These buttons can be used to fast forward or rewind the tape,
or to easily search for the tune's beginning of the tape quickly.
Playback button and indicator (> PLAY)
This button can be used to start the playback or recording of
the cassette.
(The tape will then begin moving in the left-to-right direction.)
When this indicator illuminates steadily, it indicates that this
tape deck is in the playback mode or the recording mode.
When it flashes continuaily, this is an indication that this tape
deck is in the pause mode or the recording stand-by mode.
Stop button (™@ STOP)
This button can be used to stop tape movement.