Technics RS-CH770 - Page 12

RS-CH770
Plunger ass'y Shaft [RMS0398-1]
NOTE
Notice for installing the plunger ass’y
* The shaft of plunger ass'y should be
aligned with the slot of lever.
Plunger ass'y
5. Replacement for the head block and pinch roller ass’y
+ Follow the GSD ~ G2IED of the item 1 in checking
procedure for each P.C.B. on pages 3 and 4.
* Follow the GSD ~ RZD of the item 2 in checking NOTE
procedure
for
each
P.C.B.
on
page
5.
The
illustration
below
shows
DECK2
mechanism.
*
Follow
the
GED
~
G@SED
of
the
item
3
in
main
For
DECK1
mechanism,
perform
the
same
procedure as DECK2.
component replacement procedures on page 8.
i step 1)
Release the 2 claws, and then
remove the pinch roller ass’y (R),(F).
Pinch roller ass'y (R)
[RXLO125}
Pinch roller ass'y (F)
[RXL0124]
Claw
Claw
Head block
DECK1 : RED0038
DECK2 : RED0037
Release the 2 claws,
and then remove the |claw
head connector.
Head
connector
IXTW2+5L]
ep