Technics RS-D200

'» Press to “on” (H_.=).
=.
2
_
6
Zz
nT
K} Set to position corresponding to type of tape to be
Insert the cassette.
Be sure the edge of the cassette
where the tape can be
seen faces down.
([) Press.
recording
will begin.)
used.
~>} Press to the “in” position. (B=)
ePress to release to the ‘‘out” position (mM) for
recording without using the Dolby-noise reduction system.
iy Select the recording source.
(right) @ Microphones (optional)
L
e (left)
When only one microphone is
connected at the left or right,
the line input at the connected
side is cut off. When recording
with one microphone, the line
inputs at both sides are cut off
once the balance control is slid
to the side (left or right) at
which the microphone has
been connected.
10) Set to the centre
position.
© Make the adjustment
of the recording level.
© Begin the sound source to be recorded.
¥@ Press.
(The Recording indicator will illuminate, the unit is now in the recording stand-by mode.)
@ Adjustment of the recording level
The numbers which you should use as a guide for the adjustment
of the tape !evel will differ depending upon the type of tape used
as well as the position of the noise-reduction switch.
Nouial Tape
Noise Reduction (NR) F
ath wn eere €rQ2 Tape
| Metal Tape _
Dolby NR
NR out +6 dB
@ Erasing recorded sounds
When a recording is made, any sounds previously recorded on
that portion of the tape are erased, and only the new recording
remains. To erase recorded sounds without making a new
recording, proceed as follows.
Press the “out” button.
@ Set to the minimum (0) position
© Begin recording in the usual way.