Technics RS-TR373

1
The procedures described below are an example of playback on
Deck 1.
POWER Press POWER.
(The unit will switch on.)
/ sl === Press OPEN/CLOSE, and
2 lage) then insert the cassette
SS tape.
Press again to close the cassette
holder.
Forward side Reverse side
iaas
Tape opening facing downward.
When the cassette holder is open, pressing <q, >,
<4<4 or DP will close the holder and begin the
destred functlon.
DOLBY NR Press DOLBY NR to select
the appropriate noise-reduc-
tion system.
imi = ame An
A Lt Ul bit
Each time the button is pressed, the indicators will
change in the order: |B — — off.
Select the same type as that used for recording.
When playing back a tape which was not recorded us-
tng a Dolby NR system, press so that the indicators
go off.
nee Press REVERSE MODE to
select the appropriate
Ox reverse mode.
OA
AL } c c b a
c3
Each time the button is pressed, the Indicator will
change in the order: <7 > GD +x.
| es eee ae Ss
= : One side only. ipa eo
<*>: Both sides repeatedly (up to 8 times).
&) : Both sides, once only.
(Refer to page 8.)
Press > or <.
{Playback will begin.)
> : To begin from the forward side.
<4: To begin from the reverse side
aon
Ou ci |
+e
>
Ituminates Indicates the side being played.
To play back on Deck 2, in steps 2 and 5 above, press the but-
tons ( 2 and & ) for Deck 2.
To temporarily stop playback
(Deck 2 only)
Press §I.
The “PLAY” indicator will flash.
Press once again ta resume playback.
To stop playback
Press Hf. — = we