Technics RS-TR474

RS-TR474 |
Hi RECORDING (beck 2 only)
Either normal, CrO, or meta! type cassettes can be used.
This unit is equipped with an ATC function (refer to page 10)
which automatically sets the optimum recording conditions to
match the characteristics of the tape being used. It is recom-
mended that you use this function when recording.
[Preparation
1. Switch on the power. :
2. Load a tape which has been advanced to the end of the leader
tape (the transparent part at both ends of the tape) into Deck
“"pousyNA~—- Press DOLBY NR to select 8] atc Press ATC.
the desired noise-reduction Yo Setting of the ATC (refer to page 10)
will commence, and will be completed
after approximately one minute.
When the settings are complete, the
tape will be returned to the position
from which the ATC function began,
and then the unit will enter the stop
mode.
system. (Refer to the opposite
page.)
Each time the button is pressed, the in-
dicator will change in the order:
[B] + [C] — off.
"Reverse ~~ Press REVERSE MODE to 4 rec Press REC @.
select the desired reverse (The unit will be in the recording stand-
by mode.
mode.
y
)
illuminates
Each time the button is pressed, the in-
dicator will change in the order:
er cD eK me.
| See eee
==
:
Only
one
side
will
be
recorded,
Play
the
source
in
order
to
and
then
operation
will
automatically
adjust
the
recording
sound.
stop.
Gm, &@ : Both sides (the forward
side
first,
and
then
the
reverse
Side)
99
ere
eect
eee
e
rete
renee
terete
enn
teen
tne
will
be
recorded,
and
then
operation
will
automatically
stop.
SAUANGE
If
necessary,
adjust
the
C) BALANCE control to adjust
the balance.
LEFT RIGHT ;
(Refer to the opposite page.) -
(The control should normally be set to
the center position.)