Technics SA-EX140 Operating Instructions

aUt*RTZ LOCK STEREO
[]
I--I I
L t'-) /
Listeningto radiobroadcasts
Presetting radio stations into the memory channels of this unit
makes selecting stations simple.
A total of 30 FM and AM stations can be preset.
Please remember this
If a new station is preset into a channel, the station previously
entered in that channel will be erased.
I Automatic memory presetting ] I
Automaticmemory presettingallows thisunitto search forstations
and then preset them into memory.
With this method, the channels that can be preset into the memory
are set as follows for different bands (FM or AM).
When FM stations ere preset,
For FM stations .......................................................................... 1-30
When FM and AM stations are preset,
For FM stations .......................................................................... 1-20
For AM stations ........................................................................ 21-30
] Set to the frequency from which you want to start
automatic memory presetting. (See page10.)
] Press [MEMORY] until the frequGncy begins to
change.
(Automatic memory presetting will start.)
During automatic memory presetting, the memory indicator
will flash while the frequency scrolls.
To stop, press [MEMORY] once again.
I When a preset [] ]
broadcast
station is
The memory indicator and the preset channelnumberwill be dis-
played for approximately I second.
When presetting is completed
The last stationtobe presetwillhe displayed.
IBF_J_
Frequencies may not be preset correctly_in cases where the broad-
cast waves are too strong or too weak. In such cases, carry out pre-
setting manually. (See page 12)
HI
RQT5221

Technics SA-EX140 Specifications

General

Tuning Range	FM, MW
Input Sensitivity	150 mV
Signal to Noise Ratio	80dB (line)
Dimensions	430 x 125 x 300mm
Speaker Load Impedance	8Ω to 16Ω