Technics SC-EH580

29
RQT6301
Recording operations
1
2
3
B
EH780
EH580
EH780 EH580
A
B
∫
1
2
DISC1–5
EDIT
3
∫
3
∫
∫
¥ REC
PAUSE
EDIT
EDIT
EDIT
NR Î
2
REC
2
EDIT
REC
EH680
EH680
Recording CDs
Preparation:
³Do the preparatory steps (á page 28).
³Insert the CD(s) you want to record (á page 8 or 9).
³[EH780]
Press [DISC, 1–5] on the CD changer to select the disc where you want to
start recording, then press [º] to stop the disc.
»
A
Normal recording
1 Press ["] (reverse side) or [!] (forward side) then [º] to
set the tape direction.
2 Press [´ REC PAUSE].
The deck goes into the recording standby mode and the indicator “"”
or “!” starts flashing.
3 Press [!] on the CD changer or CD player.
Recording starts automatically.
4 seconds after the CD(s) finishes, the deck goes into the recording stand-
by mode.
To stop recording
EITHER
Press [º] on the CD changer or CD player.
The deck goes into the recording standby mode 4 seconds later.
OR
Press [º] on the deck.
Recording stops immediately but the CD continues to play.
To record programmed tracks
Program tracks before step 1 (á page 15).
»
B
One touch CD editing
This function makes it easier for you to record from discs.
³When recording, if a track is cut off in the middle at the end of the front
side, it is recorded from the beginning on the reverse side.
(Ensure the reverse mode “@” is selected. )
³At the end of the reverse side recording stops and the current track will be
interrupted.
After pressing ["] or [!] then [º] on the cassette deck to set the tape
direction,
Press [EDIT].
Recording starts. In the meantime, “CD EDIT” will scroll across the display.
After edit-recording has finished, the cassette deck automatically stops.
To stop editing
Press [º] on the CD changer or CD player.
The cassette deck also stops. “EDIT OUT” scrolls across the display.
To edit programmed tracks
Program the tracks (á page 15) and press [EDIT].