EasyManuals Logo

Technics SC-EH580 User Manual

Technics SC-EH580
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
33
RQT6301
Timer operations and convenient functions
B
A
FPLAY/FREC
CLOCK/
TIMER
SLEEP
SLEEP
DIGITAL
S.WOOFER
AV EFFECT
Í
SLEEP
CH SELECT
3D AI
PROGRAM
1
23
4
56
7
890
L/-/--
CANCEL
DISC
VCR/AUX/
6CH INPUT
TAPE/
DECK 1/2
SUPER
SOUND EQ
TUNER/
BAND
2/;
1
MUTING
45
j
VOLUME
i
CD
EQ
Î
PRO LOGIC
SUPER SRND
TEST
SLEEP
Using the timers
»
A
The play and record timers
Turning the timers on and off
The timers come on at the set times if the .PLAY/.REC indicator is on.
They can be turned on and off by pressing [.PLAY/.REC].
Checking the timers
Press [CLOCK/TIMER] to select .PLAY (or .REC).
The timer conditions are shown in the following order:
Play timer:
Start time>Finish time>Source>Volume
Record timer:
Start time>Finish time>Selected radio station
The timers can be checked even if the unit is off.
Playing the unit after the timers are set
The unit can be used after the timers are set. Make sure the unit is off
before the set start time.
Note
³If you turn the unit off and on again while a timer is functioning, the finish
time setting will not be activated.
³If the unit is on, the timer will not function. The system must be in the
standby mode.
³This system retains the ON/OFF time settings until you make a new set-
ting. If you make a new ON time setting, you must make a new OFF time
setting.
³Do not turn DEMO on after setting a timer. The timers will not work while
DEMO is on.
»
B
The sleep timer
Remote control only
This timer turns the unit off after a set time.
While playing a source
Press [SLEEP] to select the time (minutes).
Each time you press the button:
SLEEP 30 ---------)SLEEP 60 ---------)SLEEP 90
^-----SLEEP OFF(---SLEEP 120(---}
To cancel the sleep timer
Press [SLEEP] to select SLEEP OFF”.
SLEEP goes out.
To confirm the remaining time
(While the timer is functioning)
Press [SLEEP].
The remaining time is shown for about 5 seconds.
To change the setting
Press [SLEEP] to display the remaining time, then press again to select the
required time.
Using the timers together
Any of the timers can be used together, but ensure the unit is off before the
start time for the record and play timers.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Technics SC-EH580 and is the answer not in the manual?

Technics SC-EH580 Specifications

FRONT SPEAKER

Speaker Specifications IconSpeaker Specifications
super woofer size17 cm cone type
woofer size12 cm cone type
midrange size12 cm cone type
Electrical Characteristics IconElectrical Characteristics
impedance (high)6 �
impedance (low)8 �
input power (music, high)60 W
General IconGeneral
dimensions240�412�259 mm
mass5.8 k�
output sound pressure level87 dB/W (1.0 m)

CENTER SPEAKER

Speaker Specifications IconSpeaker Specifications
woofer size8 cm cone type
tweeter size6 cm cone type
impedance8 �
Electrical Characteristics IconElectrical Characteristics
input power (music)160 W
output sound pressure level86 dB/W (1.0 m)
crossover frequency4 kHz
General IconGeneral
dimensions190�99�166 mm
mass1.8 k�
frequency range100 Hz–22 kHz (�16 dB)

SURROUND SPEAKER

Speaker Specifications IconSpeaker Specifications
full range size8 cm cone type
impedance8 �
input power (music)70 W
General IconGeneral
dimensions140�99�118 mm
mass0.9 k�
output sound pressure level84 dB/W (1.0 m)

SOUND PROCESSOR

EQ/SFP Section IconEQ/SFP Section
center frequency (5-band EQ)70/300/1 k/3.15 k/10 k Hz
level control�2.0, 4.0, 6.0 dB
center frequency (3-band EQ)70/1 k/10 k Hz
Pre-amplifier Section IconPre-amplifier Section
input sensitivity/impedance (VCR)250 mV/15 k�
input sensitivity/impedance (AUX)250 mV/15 k�
output level (VCR REC OUT)150 mV/1.5 k�
General IconGeneral
dimensions293�89�270 mm
mass1.5 k�
delay time20 ms (Fixed)

TUNER AMPLIFIER

Amplifier Section IconAmplifier Section
power output (stereo mode, DIN)2�25 W (1 kHz THD 1 %/6 �)
power output (pro logic mode, DIN)2�25 W (FRONT 1 kHz THD 1 %/6 �)
power output (surround)2�30 W (1 kHz THD 1 %/8 �)
FM Tuner Section IconFM Tuner Section
frequency range87.50–108.00 MHz
sensitivity1.8 �V (IHF usable)
S/N MONO70 dB (75 dB, IHF)
General IconGeneral
power supply (UK, Australia, NZ)AC 230–240 V 50 Hz
power consumption190 W
standby power consumption0.5 W

CD PLAYER

General IconGeneral
dimensions293�89�288 mm
mass2.2 k�
wavelength780 nm

CASSETTE DECK

Deck Specifications IconDeck Specifications
deck systemStereo cassette deck
track system4 track, 2 channel
recording systemAC bias
General IconGeneral
dimensions294�118.5�281 mm
mass2.1 k�
tape speed4.8 cm/s

Related product manuals