Technics SE-A1010 - Operating Procedures and Connections

AQTS006
Level controls
SE-A1010
INPUT
TERMINALS
NORMAL
D 4
SE-A1010
INPUT
TERMINALS
o e
DIREC
é
SE-A1010
INPUT
TERMINALS
ee
DIRECT
De
«De
iNPUT
TERMINALS
e ə
DIRECT
D
D
o
Connections
Example 2: For greater control over bass and treble
A-®© balance
Use one of these units to control treble (HF) and another to control
the bass (LF). Connect to speakers with bi-wiring terminals.
Connect the control amplifier to this units NORMAL terminals to
enable level control. Start adjustments from MAX (maximum).
The example shows connection to enable adjustment of treble for
overall bass-treble balance control. If required, the bass can also be
connected to the NORMAL terminals to enable L-R balance control.
Example 3: Using these units as monaural amplifiers
H-O
Use one each of these units for the left and right channels.
Complete separation of the channels is better and a greater sense
of position is achieved.
The example shows connection to speakers with bi-wiring terminals.