Need help?Do you have a question about the Technics SL-1700MK2 (M) and is the answer not in the manual?
General| Motor | Brushless DC Motor |
|---|---|
| Drive Method | Direct Drive |
| Wow and Flutter | 0.025% WRMS |
| Effective Length | 230 mm |
| Overhang | 15 mm |
| Offset Angle | 22° |
| Turntable Platter | Aluminum Die-Cast |
| Speeds | 33 1/3, 45 RPM |
| Rumble | -78dB |
| Tonearm Type | S-shaped Tonearm |
| Cartridge | Not included |
| Power Supply | AC 120V, 60Hz |
Adjust pitch control switch to center and set frequency to 262.08 kHz 0.05 kHz.
Set pitch control for 269.94 kHz frequency and adjust VR425 for LED indicator.
Adjust VR201 for complete stop within 120 270 after stop signal.
Adjust tone arm return screw to ensure proper return at end of record.
Set stylus tip to record surface distance (5-10mm) when cueing lever is up.
Adjust muting switch screw to eliminate noise during stylus placement.
To Next Page