Need help?Do you have a question about the Technics SL-1900 (M) and is the answer not in the manual?
General| Drive method | Direct drive |
|---|---|
| Speeds | 33 1/3 and 45 rpm |
| Wow and flutter | 0.03% WRMS |
| Signal-to-noise ratio | 70 dB |
| Effective length | 230 mm |
| Overhang | 15 mm |
| Stylus pressure adjustment range | 0-3g |
| Motor | DC motor |
| Turntable platter | Aluminum die-cast |
| Rumble | -70 dB (DIN-B) |
| Offset angle | 22 degrees |
| Power Requirements | AC 120V, 60Hz |
Details on drive method, motor, platter, speeds, and pitch control.
Specifications for tonearm type, effective length, and friction.
Procedures for setting the tonearm's horizontal balance and stylus pressure.
Adjusting arm lift height and automatic start/return positions.
How to adjust turntable speed using strobe dots and pitch controls.
Explanation of the B.F.G. method and electronic control system.
How back EMF is used for frequency generation and speed control.
Circuit converting B.F.G. frequency to voltage for speed regulation.
To Next Page