Technics SL-EH60

| SL-EH60
GEZD | Remove the pins.
1. Spread the boss 2. Pull out the pin in the
with © screwdriver. direction of arrow.
© screwdriver Pin
Boss aly &
7
Traverse deck ass’y
[RAE0150Z]
GED | Release the claws, and then remove the
traverse deck ass’y.
ae) Be careful not to lose the 3 springs because
those will also be removed on removal of the
traverse deck ass’y.
Floating spring (1)
Floating spring (2)
GEED | Before installing the servo P.C.B., move the
optical pickup toward the outer edge from
mark “<@”,
O In case that the optical pickup is not moved
toward the outer edge from the marking, the
rest detect switch (S701) mounted on the
servo P.C.B. may be damaged.
Rest det.
switch
BS ) Connector
j | (CN701)
@ After tightening screws, solder each motor
terminal.
Optical pickup T
Marking “<4”
, we " > Rotate the gear to move
Motor
terminals
it
:
the
side
A
of
optical
pickup toward the outer
Optical pickup edge from the marking “<q”.