Technics SL-P999 Service Manual

SL-P999
How to remove the headphones
P.C.B.
1. Remove the level control knob and nut.
2. Remove the connector (CN901).
3. Release the claw.
Headphones P.C.B.
How to remove the extension
P.C.B.
1. Remove the 2 screws @, @)
2. Push the 2 claws in the direction of the
arrow and remove the extension P.C.B. Extension
P.C.B.
Procedure
4-5-6
8-9
Procedure
723
How to remove the search P.C.B., Knob of level control
disc illuminator P.C.B. and
operation P.C.B.
C. Operation P.C.B.
1. Remove the 4 screws @~@).
2. Push the 7 claws in the direction of the arrow
and remove the operation P.C.B.
A. Search P.C.B.
1. Remove the search dial knob and nut. Note: To remove the search dial knob, push it
with a screwdriver through the front
B. Disc illuminator P.C.B. panel’s back opening.
1. Push the 2 claws in the direction of the How. to Cosh the mslnirc:e:
Cl
arrow: and remove the -LED:P:G:8: yor Proceaure . Remove the 8 screws (@~@). e When checking the soldered surface of the main
Maatuanel —4>10 | 2. Remove the 2 flat cables (CN404, CN405) P.C.B. and replacing the parts, do as shown.
p al and the connector (CN12). 1. Connect the main P.C.B. ground terminal (LINE
: piss iliuminat 3. Lift the main P.C.B. off the retention OUT terminal) to the chassis with a lead wire.
See posts on the chassis. 2. Connect the loading base ground terminal to the
Operation P.C.B._ a , 4. Remove the main P.C.B. in the direction chassis with a lead wire.
4)
of
the
arrow.
3.
Connect
the
operation
P.C.B.
ground
terminal
to
3) 7) 6) 5) the chassis with a lead wire.
4 “@ @
$s h P.C.B. --
Pree ‘ >< Note for assembly
A RS Combine the timer
switch with knob. oa
: @Pulls
Claw 0 PA “4
Timer
switch a
Connector Flat J
How to remove the timer knob and Hise? to vemoee aha frontarille pow Pea?
operation buttons 8 9
Procedure | a. Timer knob Procedure | 1 Release the 10 claws.
45-6
—8
456
7
1. Push the timer knob in the direction of
the arrow @ and remove it in the
direction of the arrow ©.
How to remove the magnet and
holder
Procedure | 1. While lifting the claw with a screwdriver,
1-2->11 rotate magnet holder in the direction of
the arrow and remove the yoke and
magnet.
2. Release the claw of the magnet holder.
“Qo Yoke
B. Operation buttons
1. Remove the 5 screws (@~®).
2. Remove the button holder.
Procedure
1-2-3
4-12
1. Remove the 5 screws (@~@).
2. Remove the flat cables (CN404,
CN405).
Button holder Magnet holder
|
|
Claw
with
projection
Magnet
holder
4p
—12—

Technics SL-P999 Specifications

General

Brand	Technics
Model	SL-P999
Category	CD Player
Language	English