DISC1 DISC2 DISC3 DISC4 DISC5
1 2 3 4 5
1 2 3 4 5
6 7 8 9 10
00OOO
b 0 >10
OCD
From the remote control
Before operation, follow the steps 1-4 of "Basic
Operating Procedure" on page 9.
If you want to start with the disc at the playing position, proceed to
step 3.
_] Press DISC.
Flashes
(1.... • (2)(3) (4)(5)mc:L r
Press the numeric button (1 -5) to select the
disc.
For example: To select disc 1, press the _ button.
The selected disc indicator will flash.
,J,
_(1]_ (2) (3) (4) (5) I [
.... I_ o,sc I_
If the disc only is selected, play will begin its first track in
about ten seconds.
If a disc is not on the selected disc tray, the changer plays the
disc at the next number.
Press the numeric button(s) to select the
track.
Track number
I ",_,i ',_, (2"'(3"(4"(5) 1 /J'7 I'1"1--11 l
.... I_ D,sc/ ._-I_ U. LI I
MIN SEC
To select • track between 1 and 10:
Press the corresponding number on the keypad.
To select • two.digit track number over 10:
Press the >10 button then one of the buttons from 0-9 to
select the "tens" digit. Then press one of the buttons from 0
to 9 to select the "unit" digit.
For example;
To select track number 20:
Press > 10, then 2, and then O.
Play begins at the track selected and continues through the
end of the last disc.
The changer will stop automatically when the last track on the last
disc finishes playing.
If you play a disc with the loading drawer open, the changer will
stop when the last track on the current disc finishes playing.
13
To Next Page
Loading...
Need help?
General
