Technics SU-G50 User Manual

[c] “TAPE” terminals
Connect a tape deck.
7 TAPE
REC QUT PLAYBACK
Cassette deck (not included)
LINE IN LINE OUT
@i | REMOTE CONTROL (TAPE) terminal
This
terminal!
is
used
to
connect
a
Technics
tape
deck
with
the
control terminal.
rey
“vcr 2/TV” terminals
Connect
a
second
video
cassette
recorder
or
TV.
©
|
VCR
(not
included)
(R) 0
®
[F | “VCR 1/EQ” terminals
Connect
a
video
cassette
recorder
or
a
graphic
equalizer.
—VORI/EQ—,
Graphic equalizer (not included)
© © LINEIN
O © LINE OUT
“TUNER” terminals
Connect a tuner.
[o]
(not included)
cb REMOTE
CONTROL
® ¢ —_® ©
Wi [REMOTE CONTROL (TUNER) terminal
This
terminal
is
used
to
connect
a
Technics
tuner
with
the
control
terminal. Connect the L-type cable (included).
[ele
“PRE
OUT/MAIN
IN”
terminals
Do
not
remove
the
shorting
pins
from
these
terminals
unless
you
plan
to
use
an
independent
preamplifier
or
main
amplifier.
(No
sound
will
be
heard
if
they
are
removed).
To
use
it
in
this
way,
consult
the
operating
instructions
for
the
additional
amplifier
or
preamplifier
that
you
plan
to
use.
io)
2 Q&S
[H| Cooling fan
The
cooling
fan
operates
at
high
output
power
levels
only.
|AC OUTLETS||~AC IN
SPEAKERS
(See text at right.)
“AC OUTLETS” (UNSWITCHED)
Power
is
always
available,
regardless
of
power
switch.
Audio equipment rated up to 60 W (total for all outlets) can be
connected here.
For (GC), (PX) areas.
AC power supply cord
Connect the AC power supply cord (included) after all other
cables and cords are connected.
Tuner (not included)
AC power supply
cord (included)
If this unit is not to be con-
nected with the tuner
This unit
Househoid
AC outlet
SU-G50
Connection to speaker systems
Two
pairs
of
speaker
systems
(main,
second)
can
be
connected
to
this
unit.
Speaker
systems
that
can
be
connected
(to
any
of
the
speaker
connection
terminals
of
this
unit)
are
speaker
systems
with
an
impedance
of
8
to
16
ohms.
Main speaker systems (not included)
Connect to the “A” terminals.
(left)
Second speaker systems (not included)
Connect to the ‘‘B” terminals.
(right)
(left)
To connect cords to terminals
@ Strip off the outer @D
covering, and twist the ——s= > =
center conductor. 15mm Twist
(19/32”’)
@ Tilt the lever back and
insert the cord. @ P=
Vel
@) Close the lever and pull
the cord gently to be
sure that it is secure. ANS
Note:
Be sure to only connect positive (+) cords tcpo sitive (+)
terminals, and negative (—) cords to negative ¢ —)
terminals.
Note:
To prevent damage to circuitry, never
short-circuit the plus (+) and minus (—)
speaker cords.

Technics SU-G50 Specifications

General

Brand	Technics
Model	SU-G50
Category	Amplifier
Language	English