7. TROUBLE SHOOTING GUIDE
TROUBLE POSSIBLE REASONS WHAT TO DO
The standby LED is not lit. Mains cable is not connected.
Check if the mains cable is plugged
into the power socket.
No picture or sound. No signal or weak signal.
Check the antenna and SCART
connectors
The settings you have done in the
menus have not been changed.
The digital set-top box was
unplugged without first going to
standby.
Before unplugging your digital set-
top box, wait for going to standby.
The remote control is not working.
· The digital set-top box is in
standby.
· Remote control is incorrectly
aimed.
· Battery exhausted.
· Press the standby key
· Check if nothing blocks the front
panel.
· Change the batteries.
You have forgotten any channel
lock code.
You should perform a “First Time
Installation”.
After you turn the receiver to
Standby mode, please note that
you have to wait 10 seconds,
before you turn it on again.
To Next Page
Loading...
General