3.2.3. AERIAL CONNECTION
If the lead from your TV aerial is currently connected into your TV, then remove this lead from your TV and connect
to the “Antenna In” socket on your STB.Please note that reception of Digital TV requires a good quality external TV
antenna. It is not recommended that the STB is connected to an internal aerial.
3.2.4. PUTTING INTO OPERATION
Ensure that all connections have been made before connection to the mains supply. Plug the STB into the mains
supply and a RED LED will light (standby mode) on the front panel. Wait for about 7 seconds to allow the STB to
“boot”. Press the Standby button and the LED turn to GREEN. You can also press one of the buttons on the front (if
some are available), to put the receiver out from standby mode.
3.2.5. SOCKETS
· TV SCART
· VCR SCART
· Two IEC Connectors, ANT IN is the antenna input. ANT. OUT is for to output the loop through of analogue
signals.
To Next Page
Loading...
General