If you get a warning
This may be due to a conflict with another camera or capture device. If this is the case you should uninstall the
software you have just loaded and also any other camera software that may be on your PC.
Uninstalling old drivers and devices
The most common problem occurring during installation is the presence of a driver for a similar, old device. The best
solution is remove all the drivers related to the old devices before installing the new driver. Make sure you delete
programs and drivers relating to old, unused and similar devices and nothing else.
1. Enter Windows ‘Safe Mode’ (press F8 when starting Windows and then select ‘Safe Mode’ from the menu which
will be displayed).
2. Click on ‘Start – Settings – Control Panel’ and double-click on ‘Add/Remove Programs’ icon.
3. Find all the programs for similar, old devices and remove these by clicking on the ‘Add/Remove’ button. In
‘Safe Mode’, it is possible for some programs to appear twice - remove all programs which appear twice.
4. Remove the camera driver for this camera.
5.
Restart the computer.
Now re-install the camera driver following the instructions in the previous pages.
message: “Capture device was not detected” when trying to open the PC cam.
WARRANTY AND DISPOSAL
If you are in any doubt about carrying out this procedure, consult a competent computer technician!
Your camera is covered by a warranty for 12 months
from the date of purchase. If a fault develops during
this period, please contact the TESCO electrical help
line on 0845 456 6767. Please have your original
purchase receipt with you when you call. This warranty
innowayaffectsyourconsumer rights.
Producedafter 13thAugust 2005.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for
recyclingadvice.
36
IMPORTANTUSER INFORMATION
Before Using Your Camera
Please read the following notes before operating your camera:
Avoid using or placing the camera in the following locations:
• Thiscamera is aprecision electronic device. Treatit withcare
• Do not attempt to service this camera. Opening or removing covers may expose you to dangerous voltagepoints or
otherrisks and you willinvalidate the warranty.
• Donot expose thiscamera to direct sunlightto avoid risk offire.
• Anyloss or damagecaused by the malfunctionof this product isthe sole responsibility ofthe user .
• Beforetaking pictures with this camera of any important occasion test the camera beforehand ensure that it is fully
functioning,that the batteries arecharged and that thereis sufficient space onthe SD card.
• Damp and dusty places. Sealed
vehicles, places exposed to direct sunlight or high temperatures. Places subject to severe vibration or physical shocks.
Locationsfull of smoke, fumes,dust or steam. Outdoorsin rain or snow.
• To ensure thecamera photographs normally, donot drop, shake orhit the camera whentaking pictures .
• Donot open thebattery cover when thepower is on.
• If water has entered the camera, immediately turn the power OFF and remove the batteries. Take the camera to
yourdealer for examination andrepair before using itagain.
Good Practice
• Ifthe lens, LCDmonitor or viewfinder surfaceis dirty, use alens brush or opticalcloth to wipe thesurface clean.
• Do touchthe lens with yourfingers.
• Do useany sharp object toavoidscratching the lens,LCD monitor or viewfindersurface.
• Cleanthe body onlywith a soft cloth.Do not use detergents,solvents or abrasive cleanerson the camera.
• Alwaystransport and storethe camera in thesupplied pouch.
NOT
NOT
1
To Next Page
Loading...
Need help?
General
