16
PLAYING AN AUDIO CD
Load an Audio CD into the player. •
The player will read the disc. Most CDs will start playing
automatically.
Play Pause:
Press the • /, button at any time to pause playback.
Press the • /, button again to continue to play the
disc.
To change track:
Press the • } or { button to skip to the next or
previous track.
Direct access track selection:
You can jump to a track number by entering the track •
number using the numeric keypad.
NOTE: If you want to jump to a track number higher than
9, press the 10+ button to add 10 to the track count, then
press one of the number buttons to add the second digit.
Fast search:
Press the • ] or [ button on the remote control
repeatedly to fast search forward or backward
through the movie.
Each time you press the button, the speed will change 2X
g 4X g 8X g16X g32X g Normal
Press • /, to resume play.
To set the volume:
Press the VOL+ or VOL- button to turn the volume •
up or down.
The volume level will be displayed briey.
When the volume level reaches ‘14’ a warning will be
displayed about hearing damage.
To raise the volume above this level, press ‘ENTER’.•
You can now increase the volume level beyond ‘14’.
Muting the sound:
Press the MUTE button to mute and un-mute the •
sound.
To stop the disc:
Press the • . button.
Play will stop, holding at the point you stopped the disc.
To resume playing the disc from the point where you •
stopped, press the /, button.
To completely stop the disc:
Press the • . button twice.
The disc will stop.
Repeat track
Repeat all
Repeat o
Elapsed time of the track playing
Remaining time of the track playing
Elapsed time of the disc
Remaining time to the disc end
Repeat play:
Press the REPEAT button repeatedly to step through •
the repeat mode options.
Audio CD time display:
Press the DISPLAY button repeatedly to change the mode
of the time display between -
To Next Page
Loading...
Need help?
General
