9.2.1 Scan setting
By default, FM scans stop at any available station (all stations). This may result in a
poor quality audio from weak stations.
Under advance settings menu, press ‘ < ’ or ‘ > ’ button to select ‘Scan setting’, and
then press ‘Select/Menu’ button to confirm.
Press ‘ < ’ or ‘ > ’ button to select 'All stations'(default) or 'Strong stations only’, and
then press ‘Select/Menu’ button to confirm setting.
9.2.2 Audio setting
By default, all stereo stations are reproduced in stereo. For weak stations, this may
result in a poor quality audio. The audio quality can be improved using mono.
Under advance settings menu, press ‘ < ’ or ‘ > ’ button to select ‘Audio setting’, and
then press ‘Select/Menu’ button to confirm.
Press ‘ < ’ or ‘ > ’ button to select 'Stereo allowed’(default) or 'Forced mono', and then
press ‘Select/Menu’ button to confirm setting.
9.2.3 System
Please refer to 9.1.5.
10 Troubleshooting
Problem: No Power.
Solution: Ensure the power adapter is properly connected.
Make sure that the radio is turned on.
Problem: The unit does not respond when pressing any buttons.
Solution: The unit may become unresponsive during use. Switch the unit off and then
on again to reset it.
Problem: Poor radio reception.
Solution: Make sure the antenna is fully extended.
Electrical interference in your home can cause poor reception. Move the unit
away from them (especially those with motors and transformers).
Problem: Desired station not found.
Solution: Weak signal. Search manually.
To Next Page
Loading...
