TechniSat DIGITRADIO 602

54
7.3.2 Connecting the mains adapter
Ensure that the operating voltage of the power supply unit matches the
mains voltage before you insert it into the wall socket.
WARNING!
Do not touch the mains plug with wet hands; electric shock hazard!
CAUTION!
Route the mains cable in such a way that nobody can trip over it.
> Connect the supplied power adapter to the port marked DC-IN (24) on the
back of the DIGITRADIO 602. Then connect the power supply to the mains.
7.3.3 Inserting the baeries into the remote control
> Open the baery compartment on the back of the remote control by sliding it
in the direction of the arrow.
> Insert the baeries (2 x AAA 1.5 V) in accordance with the polarity indicated
in the baery compartment.
> Close the baery compartment lid carefully againand ensure that the lid
retaining tabs engage in the housing.
You will need 2 micro alkaline baeries, 1.5 V, LR03/AAA to operate the
remote control. Make sure the polarity is correct when inserting them.
- Replace baeries that are losing power in good time.
- Leaking baeries can cause damage to the remote control.
- If the device is not to be used for a prolonged period, remove the baeries
from the remote control.
- Important instructions for disposal: Baeries may contain toxic substances
that are hazardous to the environment. Therefore, it is imperative to dispose
of the baeries according to the legal provisions in force. Never dispose of
baeries in normal household waste.
7. 4 General device functionality
Seings and functions can be carried out both using the buons on the device and
with the remote control. The description of the operation in this instruction manual
refers to the buons on the remote control.