TechniSat DIGITRADIO 650

79
DE
EN
FR
NL
> If you want to establish a WPS connection instead of entering the password,
proceed as follows aer selecting the WiFi network:
How you activate WPS on your router can be taken from its instruction
manual.
> Select [Press buon] on the DIGITRADIO 650 aer selecting the WiFi
network. Take note of the instructions on the display.
> Start WPS on your router by pressing the relevant buon.
> If your router only supports the WPS PIN, select [PIN] on the DIGITRADIO 650
and take note of the PIN shown on the display. You then need to enter the
PIN in the router.
20.3.2 WPS connection
> Select [Internet seings > PBC WiFi set up] if your router has the WPS
function. This establishes a direct connection to the router without having to
enter the WiFi password.
How you activate WPS on your router can be taken from its instruction manual.
> Start WPS on your router by pressing the relevant buon. Note the
Instructions on the DIGITRADIO 650 display.
20.3.3 More information about the network connection
To find out more about the current connection select [Show seings].
Select [Manual seings], if you know your network parameters and you
would like to configure them manually. Take note of the instructions on the
display.
The menu item [Net Remote PIN] can be used to configure the PIN for the
control with the TechniSat CONNECT app. The standard PIN is: 1234. The
TechniSat CONNECT app can be loaded free from the usual app stores.
Select [Delete network profile], to delete WiFi connections no longer required.
Select [Reset seings] to clear all current Internet seings.
Select [Allow WiFi connection in standby mode] if the WiFi connection
should be retained in standby mode as well. This seing increases power
consumption but enables app control via the TechniSat CONNECT app
(switching on from Standby mode).