TechniSat MULTYRADIO 600 CD IR - Page 75

75
DE
EN
NL
> Using the / buons, select a track and press the OK buon to accept
the storing.
> Then [PO2] is displayed for the second track which you can also add as
described above.
> When programming is complete, press the Playback/Pause buon to
play.
To delete programming, either press Stop 2x or open the CD tray using
the Eject buon.
16 Audio input
You can play sound from an external device via the MULTYRADIO 600 CD IR
speakers.
> Connect the external device to the AUX-IN port (19, 3.5 mm stereo jack) on
the back of the MULTYRADIO 600 CD IR.
> Use the MODE buon to select the AUX-IN audio input. [Aux-In] appears on
the display.
The playback is controlled on the external device. Do not set the volume too
low to prevent interference.
17 Other functions
17.1 Sleep function
> Press the MENU buon and then select [Main Menu > Sleep]. Alternatively:
Press the SLEEP buon (2).
> You can use the  or  buons to set the period for Sleep o in 15, 30, 45
or 60 minute intervals, aer which the device switches to standby while in
any operating mode.
A moon symbol appears in the status bar of the display with the time still
available until the MULTYRADIO 600 CD IR switches to standby.
17.2 Alarm
> Press the MENU buon and then select [Main Menu > Alarm].
Alternatively:
Press the Alarm 1 or Alarm 2 (25) buon to jump straight to alarm configuration.
17.2.1 Seing the alarm time
The alarm function cannot be operated until the correct time has been set.
Depending on the configuration, this either happens automatically or will need
to be set manually. The time can either be updated manually, via DAB+/FM or
via the Internet. For more information, see Section 19.4.