- 40 -
Electronic Programme Guide (EPG)
Some, but not all channels send information about the
currentandnextprogrammes.PresstheEPG button
toviewtheEPGmenu.
Info bar commands:
RED button:Previousday.
GREEN button: Next day.
YELLOW button: Zooms to the selected programme.
Next day:displayslteringoptions.
BLUE button:displayslteringoptions.
(RECORD):theTVwillstarttorecordtheselected
progamme. You can press again to stop the recording.
IMPORTANT: To record a programme, you should first
connect a USB disk to your TV while the TV is switched off.
You should then switch on the TV to enable recording feature.
Otherwise, recording feature will not be available.
NOTE: Switching to a different broadcast or source is
not available during the recording.
Programme Options
InEPGmenu,presstheOK button to enter the Event
Options menu.
Select Channel
InEPGmenu,usingthisoption,youcanswitchtothe
selected channel.
Record / Delete Record Timer
AfteryouhaveselectedaprogrammeinEPGmenu,
press the OK button and and Options screen will be
displayed. Select “Record” option and press the OK
button. After this operation, a recording becomes set
to the selected programme.
To cancel an already set recording, highlight that
programme and press the OK button and select the
option “Delete Rec. Timer”. The recording will be
cancelled.
Set Timer / Delete Timer
AfteryouhaveselectedaprogrammeinEPGmenu,
press the OK button and and Options screen will
be displayed. Select “Set Timer on Event” option
and press OK button. You can set a timer for future
programmes. To cancel an already set timer, highlight
that programme and press the OK button. Then select
“Delete Timer” option. The timer will be cancelled.
NOTE: It is not possible to record or set timer for two or
more individual events at the same time interval.
Recording a Programme
IMPORTANT: When using a new USB hard disk drive, it is
recommended that you rst format the disk using your TV’s
“Format Disk” option.
Torecordaprogramme,youshouldrstconnecta
USB disk to your TV while the TV is switched off.
You should then switch on the TV to enable recording
feature.
For using recording function, you should connect a
USB disk or an external hard disk drive to the TV and
the connected USB disk should have at least 1 GB
capacity and should have 2.0 speed compatibility.
If the connected USB device does not support 2.0
speed, an error message will be displayed.
NOTE: Recorded programmes are saved into the
connected USB disk. If desired, you can store/copy recordings
on a computer; however, these les will not be available to
be played on a computer. You can play the recordings only
via your TV.
NOTE: Lip Sync delay may occur during the timeshifting.
Timeshifting and recording features will not function
in radio channels. The TV can record programmes
up to ten hours.
Recorded programmes are split into 4GB partitions.
If the writing speed of the connected USB disk is not
sufcient,recordingmayfailandtimeshiftingfeature
may not be available.
Recordings of HD programmes can occupy bigger
sizeontheUSBdiskdependingonthebroadcast’s
resolution. For this reason it is recommended to use
USB hard disk drives for recording HD programmes.
Do not plug out the USB/HDD during the recording.
This may harm the connected USB/HDD.
Multipartiton support is available. Maximum two
different partitions are supported. If the disk has
more than two partitions, a crash may occur. The
rstpartitionoftheUSBdiskisusedforPVRready
features. It also must be formatted as primary partition
tobeusedforPVRreadyfeatures.
Some stream packets may not be recorded because of
signal problems, so sometimes the video may freeze
during playback.
Record,Play,Pause,Display(forPlayListDialog)keys
cannot be used when teletext is ON. If a recording
starts from timer when teletext is ON, teletext is
automatically turned off. Also the teletext usage is
disabled when there is ongoing recording or playback.
To Next Page
Loading...
Need help?
General
