EasyManua.ls Logo

TechniSat TECHNIRADIO 6 IR

TechniSat TECHNIRADIO 6 IR
316 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
150
> Use the SELECT knob to select one of the available languages and confirm the
selection by pressing the SELECT knob.
14.6 Factory seings
If you change the location of the device, e.g. when moving house, it is possible that
the saved stations can no longer be received. In this case you can reset the device to
Factory Seings to delete all the saved stations and then launch a new scan.
> Open Menu > [System seings] > [Factory seings] and press the SELECT
knob.
> Use the SELECT knob to select the [Yes] item to reset the factory seings and
press the SELECT knob.
All previously stored stations and seings will now be deleted. The device is
now in the same status as when delivered.
> The display will show [Restart ...] and the device will start with the initial
set-up wizard. Please note the scan seings in Section „8 Ersteinrichtung“ auf
Seite 111 when doing so.

Table of Contents

Related product manuals