19
7.1 Switching the device on/off
> When the device is on standby, you can switch it on by pressing the On/Standby button on
the remote control/device.
> When operating normally you can switch the device to standby mode by pressing the
On/Standby button.
When switching the device on and off, note Section 7.1 of the operating manual as well.
7.2 Calling up the main menu and navigating through the menus /functions
The following example shows how to reach the main menu and call up a submenu. The objective of the
example is to call up the Picture Settings menu.
> Press the Menu button. The main menu appears on the screen.
> Select the Settings menu item by moving the highlight over this item using the arrow keys.
> Press the OK button to open the Settings menu.
To Next Page
Loading...
